| Made from 18 gauge steel, includes partial frame rail section also known as the under floor support.
One kit is enough to do both driver & passenger sides. This kit is for our regular grade pans which are also called flat pans, even though they do have some bends in them. These pans do not have any of the stock floor udulations in them nor do they have holes in them for drain grommets. We also sell a premium grade floor pan kit that does have the stock floor configurations and holes for the drain grommets. See listing. This kit starts in the front at the point where the floor pan starts to go up at about a 45 degree angle by your feet. It goes back to the end of the seat rail where the floor pan starts to go up. As you can see from the pic, it does have a partial section that angels up to match the stock floor pan configuration. These pans also have a lip about 3/4" tall to meet the rocker panel.These units do require welding to install. The posted pic shows the pans with the front end of them closest to you. We also sell the seat mounts (not included with this kit) See listing. We can now sell these pans individually at 149.95 for either side including the under floor support. We also sell these pans with or without the under floor support for even less money. The under floor supports are also available individually. See listings. We try to carry at least 1 set of pans in stock but if we happen to be out of stock, please allow an extra week or two for us to make a new set for you. We have lots of other rust repair sections available so if you don't see what you want listed, then call us or send us an e-mail request. Box measurement: 50" x 15" x 5" .This kit fits all 1970-74 stock Coupe Z-cars Last update 03/12 | 
